diff options
Diffstat (limited to 'src/inc/sony-wf1000xm3-battery.htm')
| -rw-r--r-- | src/inc/sony-wf1000xm3-battery.htm | 22 |
1 files changed, 11 insertions, 11 deletions
diff --git a/src/inc/sony-wf1000xm3-battery.htm b/src/inc/sony-wf1000xm3-battery.htm index 6f7bbd6..1031721 100644 --- a/src/inc/sony-wf1000xm3-battery.htm +++ b/src/inc/sony-wf1000xm3-battery.htm @@ -9,7 +9,7 @@ them and use them mostly around the city to listen to podcasts and the occasional bit of music.</p> <p><img src="/media/content/sony-wf1000xm3-battery/headphones.jpg" class="size-l" /></p> -<p>After they would first slowly show signs of not holding their full +<p>After they slowly started showing signs of not holding their full charge anymore, the batteries completely died on me after some 3 years. I was fully prepared to have to throw them out when I learned that the batteries are just standard cells and can be easily swapped.</p> @@ -25,21 +25,21 @@ batteries are just standard cells and can be easily swapped.</p> class="size-s" alt="pry open" /> <img src="/media/content/sony-wf1000xm3-battery/02_lid_off.jpg" class="size-s" alt="lid off" /></p> -<p>Use a spudger or ideally two guitar picks and wedge them in to the +<p>Use a spudger or ideally two guitar picks and wedge them into the thin gap between the top cover and the base of the earphones. Don’t -worry about breaking anything. As long as the material of your tools is -plastic, you won’t damage anything. This is by far the most tedious step -of the process (if you don’t have the picks). There is a little bit of -adhesive behind the lid, so once you get the halfs to seperate you might -have to widdgle a little.</p> +worry about breaking anything, as long as the material of your tools is +plastic, you won’t damage the headphones. This is by far the most +tedious step of the process (if you don’t have the picks). There is a +little bit of adhesive behind the lid, so once you get the halfs to +seperate you might have to wiggle them loose.</p> <p><img src="/media/content/sony-wf1000xm3-battery/03_screws_out.jpg" class="size-s" alt="screws out" /> <img src="/media/content/sony-wf1000xm3-battery/04_lift_top.jpg" class="size-s" alt="lift top" /></p> -<p>With the phillips head remove the two screws that secure the visible -part in place and then carefully lift it out, flip it over. There is a -ribbon cable connecting the touch sensor and LED on the top to PCB -deeper inside the earpiece.</p> +<p>With the Phillips-head remove the two screws that secure the visible +part in place and then carefully lift it out and flip it over. There is +a ribbon cable connecting the touch sensor and LED on the top to PCB +inside the earpiece.</p> <figure> <img src="/media/content/sony-wf1000xm3-battery/05_battery_out.jpg" class="size-s" alt="battery out" /> |